Last Updated on Tuesday, May 09, 2000 at 08:44:14. by Author: Pradeep Sarin
Go into the Electronics room, locate and press the reset button on the leftmost board in the Mercury Crate (see schematic below). This causes the crate to reset and in the process of rebooting it reloads the relevant programs automatically from phobosx. (The vxworks startup script used is mercury@phobosx:~/system/etc/mercury.vxw).
After allowing a couple of minutes for the crate to reset, you need to come back to the DAQ xterm and follow the DAQ procedures outlined here.
Please DONOT try to toggle the power switch on this crate, without the express supervision of Andrei/Pradeep/Piotr..
Please send all comments and suggestions regarding this page to Pradeep. |