------------------------------------------------------------ Date: Sun Oct 14 08:13:48 2001, Shift: 00:00-08:00 Supervisor: J.I.Jordre, with: Log book#9 pages 149 - 151 Shift Summary: ------------------------------------------------------------ 1. Beam from 01:24 to 05:14 and again from 06:48 which is still going strong. ZDC rates comparable to the other experiments but barely over 200Hz at most. 2. (MRS: 4B @ 45 deg., FS: 1/5A @ 12 deg.) Run 5318 297k trigger 1 events Run 5319 130k trigger 1 events Run 5324 180k trigger 1 events by 08:00 DVM, TPC pedestal, DVM and pedestal runs 5317, 5320, 5321 and 5322. 3. T2 anodes A had ~1.05uA current at beginning of stores with default 1260V. I therefore chose to lower the anode A voltage by 20V to get down to the safer 0.85uA current. Looking at SuperMonitor, TED and TPC3D I could not gauge any loss in efficiency. The distributions of max ADC in the front part of T2 is more or less the same as the rear part of it. Therefore runs 5318 and 5324 are taken with T2 anodes A at 1240V. ZDC blue high gain ADC 1's pedestal is no good, basically just showing up as 1s in SuperMonitor plot. H1 calib. slat 1's ADC distribution is bad. Problem with TOFW slat 92 reported by YKL is in TDC only, not ADC. BBR 25 has low gain. Tile 34 still not working. TOFW calib. slat 3 top still has wide pedestals, as reported by YKL. ------------------------------------------------------------
This archive was generated by hypermail 2b30 : Sun Oct 14 2001 - 08:14:07 EDT