------------------------------------------------------------
Date: Thu Sep 27 16:25:39 2001, Shift: 08:00-16:00
Supervisor: JN, with:
Log book#9 pages 55 - 57
Shift Summary:
------------------------------------------------------------
1. No Beam 08:00-11:50
Beam 11:50-14:16
2. Data Run 4985 - T3,T4,T5 anodes off
Data Run 4986, 4987
Pedestal Run 4988
TPC Pedestal Run 4990
DVM Run 4991
3. DB informed me that T1,T2,TPM1,TPM2 are put in standby.
I had thought only T3,T4,T5 were put in standby.
This means two things:
i. I have not been putting T1,T2,TPM1,TPM2 in standby
during 'beam cycles'
ii. I have not been turning T1,T2,TPM1,TPM2 at the
beginning of shifts when there was no beam. I will
go through the BRAHVO "Check All" printouts from
my shifts tomorrow to determine which runs are
good and bad, wrt this issue.
------------------------------------------------------------
This archive was generated by hypermail 2b30 : Thu Sep 27 2001 - 16:26:25 EDT