Hi Bjoern, One can certainly check them in - as you have discovered it does in fact not really matter since the default constructor for the BrDetectorparamsMrsT0 sets the values used just fine. The parameters setup should match those in the constructor, and those read in. Do also note that since this was copied from BB there are some unused parameters that could be taken out. One important parame is fSlatlenght !! The #8 tubes do not refer to the number of slats in front of tpm1 there are 6 with the two extra ones for the moveable calibration slat. the reason the 8 is kept is mainly because this param is used by supermon. /fv > > Hi all. > > In the current DetectorParamteres.txt there is no entry for MrsT0. For > some time I've been using a modified one containing this: > > TYPE:BrDetectorParamsMrsT0 > NAME:MRST0 > fAdcGain : 1.; // Pe-> ADC conv = 1.0 > fSigmaTime :.050; // 50 psec > fSigmaAdc : 1.; // dAdc/Adc == 100% of PE statistics > fTdcConv : 0.025; // 25 pico seconds per channel (Philips 7681) > fTdcOffset : 10; // channel number for t0 > fAdcOffset : 0; // Pedestal channel number > fNoTubes : 8; // > fNpePercm : 70.0; // Number of PE per unit path length > fSignalSpeed : 0.050; // 50 psec/cm <==> 1 nsec==20cm. > fUVTLength : 4.0; // > fThetaAtt : 0.25; // Attenuation in NPE vs theta particle > fThetaCut : 1.8; // Cutoff angle for attenuation. > > Is there any reason NOT to check this into brat? If not I'll do so > tomorrow. > > -- > Bjorn H. Samset Phone: 22856465/92051998 > PhD student, heavy ion physics Adr: Schouterrassen 6 > Inst. of Physics, University of Oslo 0573 Oslo > \|/ > ----------------------------> -*- <----------------------------- > /|\ > > _______________________________________________ > Brahms-dev-l mailing list > Brahms-dev-l@lists.bnl.gov > http://lists.bnl.gov/mailman/listinfo/brahms-dev-l > _______________________________________________ Brahms-dev-l mailing list Brahms-dev-l@lists.bnl.gov http://lists.bnl.gov/mailman/listinfo/brahms-dev-lReceived on Wed Nov 12 08:54:01 2003
This archive was generated by hypermail 2.1.8 : Wed Nov 12 2003 - 08:54:10 EST