Re: broken breg build

From: Hironori Ito (hito@rcf.rhic.bnl.gov)
Date: Sun Sep 28 2003 - 13:54:28 EDT

Next message: Flemming Videbaek: "RCF weekly meeting"

Previous message: Stephen J. Sanders: "broken breg build"
In reply to: Stephen J. Sanders: "broken breg build"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello.  This is the famous problem from gcc2.96 to 3.2 in automake.  You 
must include libtoolize --automake in autogen. (or type by hand.)
I just changed autogen in breg/base and breg/hijing and commited them in 
CVS.

To build breg for hijing
1.  in breg/base
    ./autogen
    make install
2.  in breg/hjing
    ./autgen --with-cern-libdir=/afs/rhic.bnl.gov/opt/brahms/cern/2002/lib
    make install

Hiro

Stephen J. Sanders wrote:

> Hi,
> I'm trying to run HIJING but find that the breg build is
> broken.
>
> My previous brhijing no longer runs on rcas, complaining that
> libshift is not found.  If a do a setenv I find that my cern
> does point to 2002, where libshift is available.  I tried a new
> make install in the hijing directory, but again I get a complaint
> about shift.
>
> So, I thought I'd checkout the latest breg and start from
> scratch.  Bad mistake.  Autogen now gets into an
> infinite loop.  If I go to breg/base and do the
> aclocal, autmake, autoconf, configure, the configure
> also loops.  I see the same results on rcas and on
> my local PowerPC system.
>
> Any suggestions?
>
> Thanks,
> Steve

Next message: Flemming Videbaek: "RCF weekly meeting"
Previous message: Stephen J. Sanders: "broken breg build"
In reply to: Stephen J. Sanders: "broken breg build"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.5 : Sun Sep 28 2003 - 13:55:04 EDT