Just a note that I have been hung up for the last day or so reconstructing pp data with exactly the same errors. The start of these messages/errors coincided with downloading the new and improved BrDCTrackingModule + supporting stuff. I have been steping through the code trying to understand the problem, but don't have a conclusion yet. Anyway, since I have D4 positions and gaps in the DB to entertain me for the moment, hopefully all this will be solved and/or explained by the time I come back to it (hopefully tomorrow) Kris Djamel Ouerdane wrote: >Hi Pawel, > >I (Claus) had all my reduction jobs crashed because of the following >problem (from run 5394): > >End of setup >offset file: >/brahms/u/ufstasze/brahms/brahms_app/ps_app/dc/calib/calpar/T3OffsetRun6418.dat >Reading Offsets >Calibration Channels (in X,Y,U,V): 0 0 0 0 >calib file: >/brahms/u/ufstasze/brahms/brahms_app/ps_app/dc/calib/calpar/T3CalibRun6418.dat >Reading Calib Data >can not calibrate plane 1 in module1 >check it out!!! >can not calibrate plane 2 in module1 >check it out!!! >can not calibrate plane 3 in module1 >check it out!!! >can not calibrate plane 4 in module1 >check it out!!! >can not calibrate plane 5 in module1 >check it out!!! >can not calibrate plane 6 in module1 >check it out!!! >can not calibrate plane 7 in module1 >check it out!!! >can not calibrate plane 8 in module1 >check it out!!! >can not calibrate plane 9 in module1 >check it out!!! >can not calibrate plane 10 in module1 >check it out!!! >can not calibrate plane 1 in module2 >check it out!!! >can not calibrate plane 2 in module2 >check it out!!! >can not calibrate plane 3 in module2 >check it out!!! >can not calibrate plane 4 in module2 >check it out!!! >can not calibrate plane 5 in module2 >check it out!!! >can not calibrate plane 6 in module2 >check it out!!! >can not calibrate plane 7 in module2 >check it out!!! >can not calibrate plane 8 in module2 >check it out!!! >can not calibrate plane 9 in module2 >check it out!!! >can not calibrate plane 10 in module2 >check it out!!! >can not calibrate plane 1 in module3 >check it out!!! >can not calibrate plane 2 in module3 >check it out!!! >can not calibrate plane 3 in module3 >check it out!!! > > >Could you please check it out ? > >Thanks. > >Claus >
This archive was generated by hypermail 2b30 : Wed Jun 12 2002 - 18:22:14 EDT