Scalers

Record the visual scalers in the chart below.  Do not stop the scalers to make the measurements (make estimates where necessary).  Do not reset the scalers.

Scalers are reset only at 10 am.  Each morning at 10 am, the shift crew should reset the scalers and record the reset time in the online logbook.

Please write any comments you feel pertinent ('start of run', 'middle of long store', 'beams steered in our area', etc.)  

If you want to print this table without printing out the whole checklist, go here.
Time:

Blue Beam Current ( /10^6 ions):

Yellow Beam Currents (/10^6 ions):
Paddle Negative Sum  
ZDC Negative Sum  
Paddle Positive Sum  
ZDC Positive Sum  
 
PP*PN [wide]  
PP*PN [narrow]  
PP[N]*PN[N] [wide] Nge3  
PP[N]*PN[N] [narrow] Nge3  
 
ZP*ZN[wide]  
ZP*ZN[narrow]  
ZN  
ZP  
 
PP[N] N ge 3  
PP [N ge 1]  
PP[N] N ge 3  
PN [N ge 1]  
 
PP[Nge3]*PN[Nge3]*[PP*PN]  all narrow  
Events Accepted  
ZP*ZN (25 GeV - 15 ns)  
Triggers applied  
 
Pre Beam  
ZP*ZN(10 GeV - 40 ns)  
Accepted PN*PP narrow