| Instructions | Measurements | Comments | Actions To Take |
| Check that event number in the Event Display (on DAQ Xterm) is recent. | YES ____ NO ____ |
Yes: You are done with the check for this subsytem No: Check that fatalysis is running, run is started, and phatdaq is working. If run is stopped - start it at least without writing. The DAQ should be running all the time. |
|
| Restart the anasysis and check if events being updated, | YES ____ NO ____ |
Yes: You are done with the check for this subsytem No: Continue checklist |
|
| Check the 'Run state' | 'stopped' | DAQ was stopped | Checklist is finished successfully. |
| 'started' | Continue checklist | ||
| wait ~10 sec and repeat the command again: rc_status() |
|||
| Check the difference dEv between current and previous number of events | dEv>0 | DAQ is running | Checklist is finished successfully. |
| dEv=0 | DAQ was stopped due to some failure or there are no input triggers | Continue checklist | |
| Check for running messages in 'phatdaq' window | no messages | no input triggers | Checklist is finished successfully. But if you are sure that there should be triggers then call expert |
| running messages |
Something happened | Call expert |