[Brahms-dev-l] Moving data to HPSS

Hi Flemming,

   I was wondering if there are any scripts to move
data to HPSS. I would like to move the CuCu dst files
before starting to make new ones.

Selemon,

-----Original Message-----
From: Flemming Videbaek [mailto:videbaek_at_bnl.gov]
Sent: Sun 1/7/2007 8:38 AM
To: RT-RACF-BatchSystems_at_bnl.gov
Cc: Bekele, Selemon
Subject: idle condor jobs -
 
brahms:
condor jobs
rcas00xx machines, nodes.
(low) priority

It was brought to my attention and I checked that for some  reason a large number of
jobs submitted by bramreco (as part of a production around newyear), actually either stalled, or were never started
as can be seen by  'condor_q -submitter bramreco'.Since some/if not all of these jobs have been redone this jobs should not
be restarted. I removed a good number manualy from a couple of node , but left other in case you want to check some details.

I like to understand how  this happens, it also seems to have blocked further starts on the nodes in effect.
There was some problems with running out of disks space on data disk at that time. It is possible this could be a factor

could you look into this

flemming





--------------------------------------------
Flemming Videbaek
Physics Department 
Bldg 510-D
Brookhaven National Laboratory
Upton, NY11973

phone: 631-344-4106
cell:       631-681-1596
fax:        631-344-1334
e-mail: videbaek @ bnl gov

_______________________________________________
Brahms-dev-l mailing list
Brahms-dev-l_at_lists.bnl.gov
http://lists.bnl.gov/mailman/listinfo/brahms-dev-l