Hi I am not aware of easy ways to get at at error/log information on the nodes. Proof can be rather picky. What I have seen is essentially things like a) trying to access resources (files) not available in macro. b) subtle macro errors. The a) dioes not refer to the tree file only other Since you job runs with a small number of files it does not sound like b). If you by checking individual file, mean there are readable w/o errors sounds sensible to me. Flemming ---------------------------------------------------------------- Flemming Videbaek Physics Department Brookhaven National Laboratory e-mail: videbaek@bnl.gov phone: 631-344-4106 ----- Original Message ----- From: "Eun-Joo Kim" <ejkim@ku.edu> To: "BRAHMS Software list" <brahms-dev-l@lists.bnl.gov> Sent: Saturday, July 09, 2005 9:47 PM Subject: [Brahms-dev-l] proof > Dear Expert... > > > I have stupid question. > I tried to run macro to read dst file using Proof. > Macro was running all right with 10-20 files. > However, I tried to load many files, for example, all 4A 3450 setting. > Macro stopped without printing output histogram files. > I didn't check individual file. > > Should I check the individual file? > Or is there any smart way to find what's wrong? > > Eun-Joo > > > _______________________________________________ > Brahms-dev-l mailing list > Brahms-dev-l@lists.bnl.gov > http://lists.bnl.gov/mailman/listinfo/brahms-dev-l > _______________________________________________ Brahms-dev-l mailing list Brahms-dev-l@lists.bnl.gov http://lists.bnl.gov/mailman/listinfo/brahms-dev-lReceived on Sun Jul 10 08:07:07 2005
This archive was generated by hypermail 2.1.8 : Sun Jul 10 2005 - 08:07:18 EDT