Re: [Brahms-dev-l] proper procedure for BB Vertex

Actually those two setting are default , but with the new calibrations you
should rather add
bbVertexModule->UseAllAsBest();

If the 4 values needed are not present an error will appear.


----------------------------------------------------------------
Flemming Videbaek
Physics Department
Brookhaven National Laboratory

e-mail: videbaek@bnl.gov
phone: 631-344-4106
----- Original Message ----- 
From: "Johnson, Erik B" <ebj@ku.edu>
To: "Brahms Dev" <brahms-dev-l@lists.bnl.gov>
Sent: Tuesday, September 21, 2004 10:07 AM
Subject: [Brahms-dev-l] proper procedure for BB Vertex


> Brahms,
>   In the past, I remember that there is not so obvious procedure to get
the correct vertex.  All I use now is
>   BrBbVertexModule *bbVertexModule= new BrBbVertexModule ("BBVertex",
"beam-beam vertex finder");
>   bbVertexModule->SetUseSqlOffset(kTRUE);
>   bbVertexModule->SetOffsetCalib(kFALSE);
>   swModule->AddModule (bbVertexModule);
>
> Is there anything else that I need to do?
> Erik
>
>
>
> _______________________________________________
> Brahms-dev-l mailing list
> Brahms-dev-l@lists.bnl.gov
> http://lists.bnl.gov/mailman/listinfo/brahms-dev-l
>


_______________________________________________
Brahms-dev-l mailing list
Brahms-dev-l@lists.bnl.gov
http://lists.bnl.gov/mailman/listinfo/brahms-dev-l