As you may have seen a NIM module was switched today (3/15) Beware Ides of March . I have observed for some runs that the trigger 6 did not in fact trigger the LVL0 trigger logic even though the bits were enabled. I saw it earlier, and again today while looking at some data for run10881. Therefore I changed the module (being lucky enough to find a spare). This hopefully fixes the problem. Remains is still the influence on previous runs. One way to decide is look at trigger 6 before LVL) (word 2 lower 8 bits) and see if present when trigered as it should be. I do not knpw the extend of this problem, but it must be investigated carefully, otherwise a wrong normalization could be taken for triger 6 (FFS). Flemming ---------------------------------------------------------------- Flemming Videbaek Physics Department Brookhaven National Laboratory e-mail: videbaek@bnl.gov phone: 631-344-4106 _______________________________________________ Brahms-dev-l mailing list Brahms-dev-l@lists.bnl.gov http://lists.bnl.gov/mailman/listinfo/brahms-dev-lReceived on Mon Mar 15 20:17:03 2004
This archive was generated by hypermail 2.1.8 : Mon Mar 15 2004 - 20:17:22 EST