Re: brahms db access screwed up?

From: Jens Ivar Jordre (jensivar.jordre@fi.uib.no)
Date: Wed Jun 11 2003 - 17:25:21 EDT

  • Next message: Bjorn H Samset: "dAu setup and analysis question" 
    Hi Steve and Brett.

I just met the same problem. I believe the reason is that the DNS 
entries for 130.199.6.80 at BNL have not been updated properly. Our 
BrahmsMain database contains the IP address for the host of the 
calibration and geometry databases, which from within BNL (as far Hiro 
and I can figure out) still points to rcas0005.

The remedy is to put both rcas0005 and brahms-db0 lines into your 
.bratdb file. I.e. for the same DB have one line with rcas0005 as host 
and another one with brahms-db0 as host.

Best wishes from
Jens Ivar

Stephen J. Sanders wrote:
> Hi,
> Brett just tried a replay and found that he needed to change all
> of his brahms-db0 references back to rcas005.
> 
> I verified the problem.
> 
> What's up?
> 
> ...steve
> 
> 
> 


-- 
           _____________________________________________________
  ________|                  Jens Ivar Jřrdre                   |_______
  \       | Dept. of Physics                        Office: 521 |      /
   \      | Allégt 55                    Phone: +47 55 58 27 92 |     /
    \     | 5007 Bergen                    Fax: +47 55 58 94 40 |    /
    /     | Norway            E-mail: jensivar.jordre@fi.uib.no |    \
   /      |_____________________________________________________|     \
  /__________)                                               (_________\

    This archive was generated by hypermail 2.1.5 : Wed Jun 11 2003 - 17:26:13 EDT