On Wed, 29 May 2002, Jens Ivar Jordre wrote:
> Howdy fellow brahmsers.
>
> Today I checked out the latest version of BRAT and unfortunately got
> stuck in compilation. More specifically it is libtool that complains
> about not using absolute run-paths. My terminal output is the following:
>
> .....
> Making all in data
> gmake[1]: Entering directory `/home/jens/brahms/brat/data'
> Making all in abc
> gmake[2]: Entering directory `/home/jens/brahms/brat/data/abc'
> /bin/sh ../../libtool --mode=link c++ -g -O2 -o libBratDataAbc.la
> -rpath /usr/local/lib -version-info 2:3:0 -L/usr/local/lib
> -rdynamic -R -R BrClonesArray.lo BrCreationID.lo BrVersion.lo
> BrDataObject.lo BrDataTable.lo BrEvent.lo BrEventHeader.lo
> BrEventNode.lo BrEventList.lo BrFileTag.lo data_abc_Cint.lo -lCore
> -lCint -lm -ldl -lpthread -rdynamic
> libtool: link: only absolute run-paths are allowed
> gmake[2]: *** [libBratDataAbc.la] Error 1
> gmake[2]: Leaving directory `/home/jens/brahms/brat/data/abc'
> gmake[1]: *** [all-recursive] Error 1
> gmake[1]: Leaving directory `/home/jens/brahms/brat/data'
> gmake: *** [all-recursive] Error 1
> .....
>
> From ChangeLog I could not find any changes that could induce this
> behaviour. The former BRAT version I compiled, 2.3.10, did not cause any
> problems.
>
> I autogen'ed with option --prefix=/usr/local. I tried to compile on both
> my local system and on rcas0022, both with RH7.2, and the result (as one
> might have guessed) was identical.
>
> Any suggestions for remedies?
>
> Best wishes from
> Jens Ivar
>
>
...I have the same problem....
ciao
Marco
--
Marco Germinario
--------------------------------------------------
University address : Personal address
:
Niels Bohr Institute : Noerre Alle' 75,518
Blegdamesvej 17,Ta-2 : Egmont kollegium
Copenhagen, Danmark : 2100 Copenhagen
Mail: germina@nbi.dk : Danmark
Tlf : + 45 35325305 : Tlf: +45 82320518
Mob: +45 26720446
---------------------------------------------------
This archive was generated by hypermail 2b30 : Wed May 29 2002 - 13:34:41 EDT