Hi Steve and others, On Tue, 25 Sep 2001 22:37:36 -0500 "Stephen J. Sanders" <ssanders@ku.edu> wrote concerning "current BR_MULT_CAL_TMP setting": > Hi again, > It just occurred to me that in submitting the "small" changes to > correct cases where the fCalibration variable was defined improperly > when using the ascii file calibration, ... The member was in fact _not_ defined incorrectly. Since the parameter values has been input to the MySQL database at rcas0005.rcf.bnl.gov, I saw little point in carrying around the _temporary_ ASCII files anymore, and therefor removed the relevant code from the compilation. This _only_ affected the single detector calibrations for TMA and SMA. The MA Centrality calibration was not affected by this in anyway. > I left BR_MULT_CAL_TMP defined in the uploaded files. I was going > to undefine the variable, but discovered that it is actually defined > in two places: BrMultCalibration.h and BrMultCentCalibration.h. The reason for the same define in both of these files was probably some mistake (on mine or someone elses part - I can't remember). Anyway, since only the module BrMultCentModule uses BrMultCentCalibration, and no other calibrations, there's right now no reason to have BR_MULT_CAL_TMP defined in BrMultCalibration. That is, for all single detector calibrations, we should use the MySQL database and not the ASCII files. For the MA centrality calibration, we still need the ASCII file, mainly because the issue of to which detector to attribute that calibration is not resolved yet. I trust Steve, Hiro, and Flemming will figure that out at some point. > In the brat version that I downloaded this afternoon, before > starting to work on the program, one of these defines was active and > the other was commented out. The reason being stated above. > Unfortunately, I don't remember which one was which. The one in BrMultCentCalibration was defined, the one in BrMultCalibration was undefined. > Rather than guess on the status, I'm leaving both defined as of now. As soon as this European Graduate Collage is over, I'll make the nessecary changes, including the removal of the ASCII files from asciidata/mult, since they are no longer relevant. > I have the new energy calibration of the Si and tile detectors and > hope to upload this calibration, as an ascii file, tomorrow. Looking forward to that. As soon as you have the pedestal, gap, pulser, and gain calibrations we can do the SDE centrality calibrations. May I suggest you take a look at some of the stuff in my CVS area, subdir jobs/calib. There's a few utils for commiting stuff to the MySQL db. Yours, Christian Holm Christensen ------------------------------------------- Address: Sankt Hansgade 23, 1. th. Phone: (+45) 35 35 96 91 DK-2200 Copenhagen N Cell: (+45) 28 82 16 23 Denmark Office: (+45) 353 25 305 Email: cholm@nbi.dk Web: www.nbi.dk/~cholm
This archive was generated by hypermail 2b30 : Thu Sep 27 2001 - 12:13:32 EDT