Hello. I made few more figures about Vertex correlation plots. They are located in "http://pii3.brahms.bnl.gov/~hito" . 1. bbz_TPM1z.ps shows BB Vertex against TPM1 Cluster vertex. Look at the value p1. It is less than one. This makes sense since the pad spacing used is incorrect. In fact, it was wider than it should be. This makes the slope to be less than one. It makes sense. 2. zdcz_TPM1z.ps shows ZDC Vertex against TPM1 Cluster vertex. It is basicly the same as the BB's figure. But, my slope (p1) is different from Bjorn's one. Why??? 3. bbz_TPM1z2.ps.gz shows the correlation between BB Vertex and centrality (BB Mult and Tile SumAdc). It is seen that the slope is relatively flat until the half of Maximum centrality. Then, it curves up. 4. zdcz_TPM1z2.ps.gz shows the correlation between ZDC Vertex and centrality (BB Mult and Tile SumAdc). It is clearly seen that the behavior of ZDC Vertex is different from BB Vertex. It is flat (or going down to ) until 1/8 of maximum centrality. Then, it starts to go up very linearly with centrality. Also, the slope is steeper than that of BB. I hope these figures will help debugging the vertex. Hiro
This archive was generated by hypermail 2b29 : Wed Mar 21 2001 - 16:21:54 EST