Hello, everybody.
I just checked out a fresh version of brat. "make" works OK, but when
you do "make install" it crashes, complaining:
/usr/bin/ld: cannot open -lBrat_Base: No such file or directory
Any ideas anybody?
Below is the message I was about to send yesterday, when I discoverd,
that brat is not compiling. It didn't improve overnight, so I send it
anyway:
I tried to satisfy many different requests and made some changes:
BrRdoBB.h
==========
Added two methods:
Float_t GetMult() -- returns BB non-corrected multiplicity by
Big Tubes
only (some of hits in all Big Tubes).
Int_t GetTimeMethod() -- returns timing method as Int_t to be
compared
with:
BrRdoBB::kTimeFromBigTubesBB - Best method, works in
most ca
ses
BrRdoBB::kTimeFromSmallTubesBB
BrRdoBB::kTimeFromFastTubesBB
SetMult() and SetTimeMethod() are added as well.
BrRdoModuleBB.cxx
=================
in Init()
- Checks for BrCalibrBB.dat before reading from it.
- If can not find it even in $BRATSYS/params/bb/, throws BrFatal
and
aborts the code
in Event
- t0 calculations are completely redone.
- VertexZ is calculated by methods. It tries best method
BigTubes
first, then Small and then Fastest, setting the appropriate value in
SetTimeMethod()
- Multiplicity calculations are added by SetMult()
It works nice for me, so ,please, report any problems.
P.S. Flemming, could you, please, tag this new brat version? Thanks,
--
Yury Blyakhman.
\\\|///
\\ - - //
( @ @ )
+------------------------o00o-(_)-o00o-------------+
| New York University Phone: (212)998-7762 |
| Department of Physics Fax: (212) 995-4016 |
| 4 Washington Place E-mail: |
| New York, N.Y. 10003 Yury_B@physics.nyu.edu |
| Mobile : (646)528-7187 |
| Home phone: (718)934-1851 ICQ# 2330402 |
+--------------------------------0ooo--------------+
ooo0 ( )
( ) ) /
\ ( (_/
\_)
This archive was generated by hypermail 2b29 : Fri Nov 17 2000 - 09:42:12 EST