tpc code updates.

From: Flemming Videbaek (videbaek@sgs1.hirg.bnl.goV)
Date: Thu Oct 12 2000 - 10:04:36 EDT

  • Next message: Stephen J. Sanders: "memory leak associated with running TestGeantDig" 

    Hi, 

I has been nessecary to be able to remove sequences that corresponds to bad pads on TPC. 
Many runs exsist where a section of a FEE was misbehaving with resulting nonsense sequences.
An example of this is T2 row 6 pad 80-95 for most runs since the last downloaded pedestal run
(mid 24.. to end of run). Talking to Konstantin this is clearly sotghing that should be in a database
but as for temp measure this was added to BrDetectorParamsTPC. More on thsi later.

...
Added a row,pad map to BrDetectorParameters. This padmap is meant to maintain
the status of each single pad i.e. instrumented, dead etc. So far the default is
to have all pads active. The BrTPCPreprocess module is also changed to check all
sequences for active, non-active pad status.


modified code
    BrDetectorParamsTPC.h .cxx BrTPCpreprocess.cxx


--------------------------------------------------------
Flemming Videbaek
Physics Department
Brookhaven national Lab

tlf: 631-344-4106
fax: 631-344-1334

email: videbaek@bnl.gov

    This archive was generated by hypermail 2b29 : Thu Oct 12 2000 - 09:23:04 EDT