On Mon, Jul 10, 2000 at 07:38:37PM -0400, NBI Group at BRAHMS - BNL wrote: > Hi Konstantin > > I turned on the HV on H2 and it seems that the HV is still ~25 V to high > for some of the channels. It seems to me that it was the channels where > the problem was before. Could you check it out ? > > I just noticed it when I was turning the HV off. It was not there in the > beginning. Problem confirmed. If you make an access to look at the other H2 HV bad channels, I suggest that you reseat this card- unscrew it, pull it out then push it back and screw it in. That may or may not clear the problem for good or temporarily. -- Konstantin Olchanski Physics Department, Brookhaven National Laboratory, Long Island, New York olchansk@bnl.gov
This archive was generated by hypermail 2b29 : Thu Jul 20 2000 - 20:24:48 EDT