The default setting for MTP2 has been updated to reflect the actull configuration as setup for the IR. The values are quite different than in the CVS file.padsizes, no pads, no rows.. I guess this is the difference between a virtual geant detector where many parameters will work and an actual detector for which real events have been seen. I have further changed the DC DCPlane parameters. The excat position of the planes is not completely clear- but present values have been taken from the "DC construction book". Staggering and wire-wire spacing is 0.55 and 2.2 for T4,T5. T3 ok. The distances has to fit 8 planes into 12.50 cm and the active depth is 1.0 cm per plane, so I have put the DCplane at +-0.75,+_2.25 etc. With this change it does fit inside the geant active area's. -------------------------------------------------------- Flemming Videbaek Physics Department Brookhaven national Lab tlf: 516-344-4106 fax: 516-344-1334 email: videbaek@bnl.gov
This archive was generated by hypermail 2b29 : Wed Mar 29 2000 - 15:02:28 EST